Keter Door Bar/Bolt WLHD for Store-It-Out Prime/Nova, Max, Arc & Ultra

3D printed replaced bolt/bar for Keter Store-It-Out Prime/Nova, Max, Arc & Ultra. The Keter part number is WLHD, please check that this is correct for your storage box before ordering. You can find it in your instructions manual and possibly on the original part.

Made with UV and heat-resistant PETG plastic. Reinforced in areas where the original Keter part commonly breaks.

As it is 3D printed, there may be some slight imperfections but they do not affect the strength of the bolt.

Tracked shipping.

How to install:

I recommend following Keter's guides for this: as I certainly forgot how I installed the original bolt.

1. You must first remove the part that holds the bolt (WLBP) on the right door, you can leave the left side alone.
2. Slide the bolt in like the original and pop it into the other side. You won't be able to pop it into the other side if still attached to the door, there will be no give or leeway to do so.
3. Rescrew the back into the door.
4. Finished

The model was created by help5 on Thingiverse and is licensed under the Creative Commons – Attribution.