7 Foot Mexican Palm Palapa Kit- Round- 1 Pole

7 Foot – 1 Pole Mexican Palm Palapa

Palapa umbrellas are also known as thatch umbrellas, tropical umbrellas, thatch palapa, grass palapa, tiki umbrella, or palapa structure. Sitting under a palm palapa will instantly make you feel as if you're on a beautiful tropical beach. There's nothing better than to relax in the shade of a palapa. Now you really can vacation at home!
Each Kit with Standards Options Includes

2 pieces or layers of pre-woven thatch (See the difference between 1, 2 and 3 layers Click Here)
6'' diameter x 120" long pole
Pre-assembled rafter
1/4" thick x 2-1/2" wide, flat Purlins/Rib Roof Framing
Special composite fascia trim
All necessary hardware
Step-by-step instructions
The Mexican Palm Thatch lasts outdoors approximately 2-8 years depending on the climate. If there is a lot of humidity, wind or rain, your thatch will last closer to the lower end of the spectrum. When the palm thatch needs to be replaced, and if caught soon enough it may be possible to only replace the top layer of thatch (2 layers is the standard option.) You can purchase replacements under Thatch Roof Materials & Extras – Mexican Palm Thatch.

Our 6 inch diameter poles extend to 2 inch diameter pine rafters. The thatch is hand woven Mexican rain-cape thatch and comes in 2 easy to install pieces up to 14 ft. diameter structures. (*2 unless standard option is changed)
Palapa sizes are a rough estimate because of the following. Your 7 foot palapa will have a 6 foot diameter frame and we estimate the thatch to overhang the frame by 6 inches on all sides. If you were to measure from one side of the palapa to the other including the thatch you should measure approximately 7 feet. We estimate all of the round Mexican Palm Palapas to have a 1 foot overhang. All our round Mexican Palm Palapas will have a frame 1 foot smaller then the advertised overall size of the palapa.

General Tools and materials needed for installations:
Usually at least 2 people
Drill with screwdriver bit (impact work great)
Sockets & Wrench
Free standing ladder(s)
Level(s)
Wheelbarrow and shovel (depending on post installation method)
Cement (depending on post installation method)

Installation Difficulty:
2 out of 5 – This means that this type of palapa is moderately difficult to set up.
*Note: Installation difficulty increases proportionally with the size of palapa.

Basic Installation Instructions:
Dig a hole in ground 18''-24 in diameter or core a hole into your bar surface 6-10 inches in diameter (depending on palapa size) and place main pole in hole
Connect pre-assembled rafters to main pole
Attach composite fascia trim to ends of rafters (makes structure circular)
Place wood purlins/ribs over rafters (these keep the thatch up between rafters)
Attach thatching to roof frame
**Much More detailed instructions come with kit***

Warning: New natural palm grass thatch (Tahitian & Mexican) have lots of dust and oils on them or in them and should be rinsed thoroughly before or after installation to prevent staining of concrete, grout, or other porous material that the runoff will encounter. It is highly recommended that all porous surfaces including the wood of a structure be sealed to prevent staining even if thatch is washed or rinsed.